FACTORY ONLINE — HAIYAN, ZHEJIANG
MON–SAT 8:30–17:30 (GMT+8) [email protected] WA +86 183 5724 1165
Get a Quote→ Contact
Home/News/Industrial VFD Applications

Pump VFD Retrofit Site Survey for Panel Builders

Pump VFD Retrofit Site Survey for Panel Builders

Before requesting a quotation, document the existing pump, motor and control panel. Confirm whether the project is replacing a failed drive or converting a fixed-speed installation. Identify which equipment stays and who signs off on changes.

Survey the motor and electrical panel

Record motor type, rated voltage, current, frequency and power from the nameplate. Identify the electrical supply, existing starter or drive, cable route, enclosure dimensions and ambient conditions. Ask the supplier to confirm the proposed drive against the motor current and site conditions.

Map commands, feedback and operating modes

List the start/stop commands, pressure or level feedback, alarm contacts and signals to the building controller. If the installation has a bypass or local/remote selector, document the intended behavior in each mode and have the panel builder check the interlocks.

Set acceptance checks before ordering

Agree on the operating range, a representative duty point, what measurements to record and who tests the alarm and sensor-loss responses. Request a dated set of drawings and approved settings after commissioning. Qualified personnel should confirm protection and wiring for the specific equipment.

Review the IDEEI 3300M series

Share this guide LinkedIn Facebook WhatsApp
RFQ — RESPONSE WITHIN 24 HOURS

Send the nameplate.
We size the drive.

Motor photo, pump curve or project spec — our engineers return a matched selection, wiring guidance and a parameter preset file.

MAIL ● [email protected] WA   ● +86 183 5724 1165 Get a Quote→ Send Inquiry